Pod tachometer contact broken

Replies to This Discussion

Permalink Reply by Hoberman on October 22, 2009 at 11:27pm

This is really old but on the off-chance you haven't found your answer yet I'll go ahead and post. I assume you're talking about the dash-end connector, not the one inside the tach itself.

I've attached a photo of the connector. Pin 1 is to the left in the picture. The cable itself should be marked with a stripe; this is pin 1, with each conductor connected in order (i.e., not crossed) to pins 1, 2, 3, 4, 6, and 8 of the connector. Pins 5, 7, and 9 are left unconnected.

If you're handy with a multimeter, you should see about 150 ohms between pins 1 and 2 and between pins 3 and 4. Pins 6 and 8 are for the tach illumination. It's a plain old filament light bulb so you should see 10-20 ohms between the pins.

If that's not what you're looking for let me know and I'll see if I can help.

Hoberman

Attachments:

• IMG_4912 (Small).JPG, 45 KB

▶ Reply to This

Permalink Reply by Mario Celegin on October 26, 2009 at 7:03pm

Thank's very much. This is exactly what I was asking for.

Highly appreciated!
/Mario

▶ Reply to This